Interface Board Sdcs-Com-8 - ABB DCS800 Hardware Manual

Interface Board SDCS-COM-8

This board must be used together with a DCS800 to provide same serial communication DDCS options
as ACS800.
Furthermore the board is equipped with four optical channels (max. data transmission speed is 4 Mb for
each optical channel):
• Channel 0 is used to communicate data from the overriding control (FCI, APC2, AC800M, Nxxx-xx
(adapter modules for fieldbus), AC80) or via adapter modules from other controllers) to the
DCS800-drive.
• Channel 1 is used for DDCS I/O extension. AIMA-01 board see separate documentation.
• Channel 2 (Master-Follower) is used to operate two or more drives dependent on each other.
Channel 3 is prepared to connect the PC tool for commissioning and maintenance (DriveWindow).
• Connector X19 is used for CDP 312 panel as well as interface board NDPI.
Explanation of LEDs on SDCS-COM-8
LED
V6
V1
Type
SDCS-COM-81 from D...F
SDCS-COM-82 from D...F
SDCS-COM-81 from G...
SDCS-COM-82 from G...
Color of optical components:
5 Mb -> blue
Remark:
SDCS-COM-8
D200
V6
V1
X19
conductive support
color Meaning
green 5 V supply ok
red blinking: boot procedure
permanent: SDCS-COM-8 fault
Revision optical components
Ch 0 Ch 1
PLC I/O
10 Mb 5 Mb 10 Mb 10 Mb other interfaces
5 Mb 5 Mb 10 Mb 10 Mb Fieldbus adapter
10 Mb 5 Mb 10 Mb 10 Mb other interfaces
5 Mb 5 Mb 10 Mb 10 Mb Fieldbus adapter
driver current maximum 30 mA
Only channels with the same components (e.g. 10 Mb component) may be connected to
each other.
3ADW000194R0611 DCS800 Hardware Manual f us
148
Channel 0 used for
Ch 2 Ch 3
M/F DW
modules Nxxx-xx
modules Nxxx-xx
D100
D400
COM_8_layout_b.dsf
max. driver current
Ch 0, 2, 3 50 mA
Ch 2, 3 50 mA
Ch 0, 2, 3 50 mA
Ch 2, 3 50 mA
Technical data
79
Cunduc-
tive sup-
port
x
x