Danfoss FC 300 Profibus Manual page 21

FC 300 Profibus
How to Configure the System
The FC 300 GSD file is now imported and will be
accessible via the following path in the Hardware
catalogue:
Open a Project, set up the Hardware and add a
PROFIBUS Master system. Select FC 300 then drag
and drop it onto the PROFIBUS in the Hardware
diagram.
A window for the address of the FC 300 now
appears. Select the address from the scroll-down
list. Note that this address setting must match the
previous address setting in par. 9-18 Node address.
21
MG.33.C2.02 - VLT is a registered Danfoss trademark