Chattanooga Revolution Wireless Service Manual page 32

DEVICE ISSUES
The module's battery has run out
The remote control shows a discharged battery symbol. Shown on the channel
where the problem was detected (in this case channel 4).
Problem Possible cause
Low module During the
battery stimulation a module
may turn out to be
discharged.
The stimulation is not producing the usual sensation
Problem Possible cause
Unusual Improper electrode
stimulation placement
sensation
Low intensity
The stimulation causes discomfort
Problem Possible cause
Stimulation is Amplitude (intensity)
uncomfortable is too high or wrong
program
Electrodes are too
close together
Damaged or worn
electrodes or lead
Solution
1. You can stop the stimulation and recharge the module with the empty
battery.
2. You can set aside the module with the empty battery and continue your
stimulation session without it.
Solution
1. Check that all the settings are correct and ensure that the electrodes are
positioned properly.
2. Change slightly the positioning of the electrodes. Electrodes must be a
minimum of 2 inches apart.
3. Replace the electrodes
4. If the output is too weak, check that the channels are active, and then
increase intensity
Solution
1. Check that all the settings are correct and ensure that the electrodes are
positioned properly.
2. The electrodes are losing their bonding strength and are no longer
providing suitable contact with the skin.
3. Reposition the electrodes. Electrodes must be a minimum of 2 inches
apart.
31
Note: Final accessories may differ from the picture