Setting Guidelines; Disturbance Report Drprdre; Identification - ABB RELION 650 Series Applications Manual

1MRK 505 363-UEN A
created from any available signal in the IED that is connected to the Event function (EVENT).
The EVENT function block is used for LON and SPA communication.
Analog and double indication values are also transferred through the EVENT function.
15.5.3

Setting guidelines

The parameters for the Event (EVENT) function are set via the local HMI or PCM600.
EventMask (Ch_1 - 16)
The inputs can be set individually as:
NoEvents
•
OnSet , at pick-up of the signal
•
OnReset , at drop-out of the signal
•
OnChange , at both pick-up and drop-out of the signal
•
AutoDetect
•
LONChannelMask or SPAChannelMask
Definition of which part of the event function block that shall generate events:
Off
•
Channel 1-8
•
Channel 9-16
•
Channel 1-16
•
MinRepIntVal (1 - 16)
A time interval between cyclic events can be set individually for each input channel. This can be
set between 0 s to 3600 s in steps of 1 s. It should normally be set to 0, that is, no cyclic
communication.
15.6

Disturbance report DRPRDRE

15.6.1

Identification

Function description
Disturbance report
Disturbance report
Disturbance report
Application manual
It is important to set the time interval for cyclic events in an optimized way to
minimize the load on the station bus.
IEC 61850 identification
DRPRDRE
A1RADR - A4RADR
B1RBDR - B8RBDR
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
- -
- -
Section 15
Monitoring
IP14841-1 v1
M12811-3 v2
M12811-5 v2
M12811-15 v2
M12811-29 v3
M12811-34 v1
IP14584-1 v2
M16055-1 v7
297