Orbit Measurement; Orbit Measurement With Dc Offset (Gap) - Adash VA4 Pro II User Manual

ADASH Adash 4400 – VA4Pro

Orbit measurement

The A1 means, that the channel 1 is used for A orbit channel.
B2 - channel 2 is used as B.
The position of A1 and B2 matches the sensor angles used for measurement (see Sensors definition). The
knowledge of those angles enables to draw the correct shape of orbit.

Orbit measurement with DC offset (gap)

An orbit contains two time signals. Each time signal could be modulated to a gap value as referred in Time
signal with DC offset (gap) chapter. If you setup gap channels for orbit's time signals the resulting orbit will be
displayed with an offset.
70
For further technical and contact information visit www.adash.com or email: info@adash.com