Orbit - Adash VA5 Pro User Manual

Virtual unit
Table of Contents

Advertisement

ADASH
Adash 4500 – VA5Pro

Orbit

The A1 means, that the channel 1 is used for A orbit channel, similarly B2 means channel 2 is used as B.
The position of A1 and B2 matches the sensor angles used for measurement (see Sensors definition). The
knowledge of those angles enables to draw the correct shape of the orbit.
Orbit measurement with DC offset (gap)
An orbit contains two time signals. Each time signal could be modulated to a gap value as referred in Time
signal with DC offset (gap) chapter. If you setup gap channels for orbit's time signals the resulting orbit will be
displayed with an offset.
77
For further technical and contact information visit
www.adash.com
or email: info@adash.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

A4404 sab

Table of Contents