Measurement; Sensor Mounting; Various Screens With Measurements - Use Arrow Buttons - Adash 4900 - Vibrio M User Manual

Measurement

sensor Mounting

Screw the magnetic base onto the sensor.
Do not forget to remove the plastic cover
and the metal washer (it closes the magnetic
field to prolong the lifetime of the magnet)
before measuring. Place the plastic cover and
the metal washer back on the magnet after
measuring.
Place the magnet on a measuring point very
carefully. The best way how to do is to rest the
edge of the magnet on its side and then slowly
attach the sensor to the measuring point. If
you bring the magnet near to the machine
with its whole area hitting the machine all of a
sudden then the strong impact can irreversibly
destroy the sensor.
If you use a measuring tip instead of a magnet,
the measured values are not going to be
stable. This is not surprising because the
measured values depend considerably on the
pressure of the tip at the measurement point.
A magnet which attaches a sensor generates
a constant pressure so the values are stable.
Attention!!! Use the measuring tip only
in hard to reach places where it is not
possible to place the magnetic base .

Various screens with Measurements - Use Arrow buttons

The instrument offers many various vibration measurements. Every type of measurement uses its
own screen. When you move between screens, then you will see all measurement results.
Use the arrows for moving.
www.adash.com
AdAsh 4900 - Vibrio M
Use arrows to change screen .
7