Red Pitaya HAMlab User Manual page 98

HAMlab, Release 1.0
Receiver Specifications
Architecture:
ADC Sampling Rate:
ADC Resolution:
Wideband Frequency Coverage:
MDS (min. detectable signal):
Preamp OFF at 14MHz
Preamp +15dB at 14MHz
Preamp +30dB at 50MHz
Preselectors:
Transmitter Specifications
Architecture:
TX DAC Sampling Rate:
TX DAC Resolution:
RF Output Power:
Transmitter Frequency
Range:
Low Pass PA Filter Bands:
Emission Modes Types:
Harmonic Radiation:
3rd-Order IMD:
Cooling:
Note: C25 also supports 6m operation and has all necessary output filters for 6m, anyhow STEMlab 125-14 ouput
signal is not pure enough to comply harmonic regulations for 6m
General Specifications
Antenna Connector:
Antenna Impedance:
RF Output Power:
Maximum Interconnect Cable
Length Ethernet:
Power connector:
94
Direct Digital Sampling
125Msps
14 bits
25 kHz - 62.25 MHz
MDS (typ)@ 500Hz BW
-113dBm
-130dBm
-135dBm
More MDS measurements.
Available as add-on module (comming soon)
User can also connect own preselectors/filters
Direct Digital Up-conversion
125 Msps
14 bits
up to 10 W CW and SSB at @ 13.8 V input voltage (max. 15 V)
160 - 10 m (amateur bands only)*
160m / 80 m / 40 m / 30m / 20 m / 17m / 15m / 12m / 10m / 6 m
(possibility to changed it to any range 1.8 - 50 MHz)
A1A (CWU, CWL), J3E (USB, LSB), A3E (AM), F3E (FM), DIGITAL (DIGU,
DIGL)
DIGITAL (DIGU, DIGL)
better than -45 dB
better than -35 dB below PEP @ 14.2 MHz 10 Watts PEP
copper heat spreader
ANT1 and ANT2 available on SMA connectors Included one cable with
SMA to SO-239 UHF
50 Ohm Unbalanced
up to 10 W CW and SSB at 13.8 V input voltage (max. 15 V)
100 meters (328 feet), Category 5 cable
PowerPole
Chapter 5. HAMlab 160-6 10W 10W Specifications