HAMlab, Release 1.0
4. At the end of the installation you are asked if you want to run PowerSDR software immediately, feel free to do
so.
5. PowerSDR software will start with the calculation of the FFT wisdom file, which will take a while depending
on the CPU power of your computer. This is only done once, even after updating the software to a new version
in the future:
6. After starting the PowerSDR software you will be led through the PowerSDR software specific setup wizard
which lets you configure the software to use it with your STEMlab. Pick the HAMlab/STEMlab radio model.
18
Chapter 2. Quick start