Table of Contents
Advertisement
SHOW: Shows or hides the curve associated with the channel.
INVERT*: Reflects the graph on the X axis.
Probe attenuation: The division that was set on the probe. (must be selected manually)
Vertical offset: Moves the curve up or down.
LV and HV: Are osciloscope input range options of your HAMlab implemented via attenuator.
• HV represent higher voltage range from -20 to +20 V.
• LV represent low voltage range from -1 to 1 V.
AC and DC coupling: HAMlab enables you to mesure signals in two coupling modes AC and DC.
• AC Osciloscope will show only AC component of a signal.
• DC Osciloscope will show both AC and DC components of a signal.
3.1. Oscilloscope with Signal Generator
HAMlab, Release 1.0
51
Advertisement
Table of Contents
