HAMlab, Release 1.0
Other additional requirements
In addition to the supplied accessories, software and cables supplied with the HAMlab, you will need to provide the
following:
• An HF-Antenna or dummy load with BNC or SO-239 connector
• powered stereo speakers (computer type) or stereo headphones
• router with enabled DHCP and connection to the internet
• good RF ground
• HAMlab compatible Microphone available in HAMlab
• A stabilized DC 13.8 VDC, 4A Power Supply
• Oscilloscope and logic analyzer probes available in HAMlab
• DJControl Instinct S Series available from
SDR application requirements:
• Personal computer (PC) running Windows 7 or later. Either 32 or 64-bit operating systems are supported.
Instrumentation applications requirements:
• All instrumentation applications are WEB based and don't require the installation of any native software. Users
can access them via a browser using their smartphone, tablet or a PC running any popular operating systems
(macOS, Linux, Windows, Android or iOS).
Start using HAMlab measurement instruments
Connecting the cables
Back panel connections
HAMlab should be powered by DC 13.8 V Power Supply that can provide at least 4A of constant power. Make sure
that is turned off and then use DC power cord with Anderson Power Pole™ connector to connect it with HAMlab.
RED wire is positive (+) while BLACK wire is negative (-), double check to not mix the colours or polarity! Don't
turn on the power supply yet.
6
shop
.
shop
.
Hercules
or other midi controller.
Chapter 2. Quick start