Start Using Hamlab As Radio Station - Sdr - Red Pitaya HAMlab User Manual

HAMlab, Release 1.0
• Spectrum Analyzer

Start using HAMlab as Radio Station - SDR

Connecting the cables
Back panel connections
Antenna - Connect an HF antenna with nominal 50 Ohm impedance to the SO-239 connector.
Note: If you prefer BNC connector you can remove HAMlab top cover and reconnect it from SO-239 to BNC.
Ground - Remove the thumb screw marked GND. Connect your central station ground to the thumb screw and screw
it back into the radio.
Speakers - connect powered stereo speakers to the jack
Tip: You can instead of speakers connect headphones on the front panel.
USB cable (3) - connect the HAMlab with the PC using USB 2.0 Cable - A-Male to Mini-B. USB cable will provide a
way for PowerSDR software to use HAMlabs audio outputs. USB cable for audio is only required for HAMlab 80-10
10W model.
10 Chapter 2. Quick start