HAMlab, Release 1.0
Power button
Momentarily pressing power button (1) will turn the HAMlab ON. It normally takes 30s from the button press until
the HAMlab is ready to be used. Once HAMlab is ON, holding the power button pressed will cause the proper shut
down of the device. Blue LED indication on the power button indicates that device is turned on.
Note: In case that system halts and becomes unresponsive, device can be turned off by holding power button for a
few seconds / until the blue LED is turned off.
SDR
Microphone connector (RJ45)
The HAMlab 80-10 10W front microphone connector (2) can support Kenwood KMC 30 electret microphone or
compatible types.
Front panel view microphone pinout
84
Chapter 4. HAMlab 80-10 10W Specifications