Table of Contents
Advertisement
HAMlab, Release 1.0
Receiver Specifications
Architecture:
ADC Sampling Rate:
ADC Resolution:
Wideband Frequency
Coverage:
MDS (min. detectable
signal):
Preamp OFF at 14MHz
Preamp +15dB at 14MHz
Preamp +30dB at 50MHz
Preselectors:
Transmitter Specifications
Architecture:
TX DAC Sampling Rate:
TX DAC Resolution:
RF Output Power:
Transmitter Frequency Range:
Low Pass PA Filter Bands:
Emission Modes Types:
Harmonic Radiation:
3rd-Order IMD:
Cooling:
Microphone connector:
Microphone impedance:
General Specifications
Antenna Connector:
Antenna Impedance:
RF Output Power:
Maximum Interconnect Cable Length Ethernet:
Power connector:
80
Direct Digital Sampling
125Msps
14 bits
25 kHz - 62.25 MHz
MDS (typ)@ 500Hz BW
-113dBm
-130dBm
-135dBm
More MDS measurements.
Available as add-on module (comming soon)
User can also connect own preselectors/filters to back panel BNC connectors (RX1
IN, RX1 OUT)
Direct Digital Up-conversion
125 Msps
14 bits
up to 10 W CW and SSB at @ 13.8 V input voltage (max. 15 V)
80 - 10 m (amateur bands only)
80 m / 40 m / 20 m / 10 m (possibility to changed it to any range 1.8 - 50 MHz)
not limited by HAMlab hw, depending on 3rd party SDR software used
better than -45 dB
better than -35 dB below PEP @ 14.2 MHz 10 Watts PEP
copper heat spreader
RJ45
600 ohm unbalanced
SO-239 UHF or BNC back panel connector (ANT1, ANT2)
50 Ohm Unbalanced
up to 10 W CW and SSB at 13.8 V input voltage (max. 15 V)
100 meters (328 feet), Category 5 cable
PowerPole
Chapter 4. HAMlab 80-10 10W Specifications
Advertisement
Table of Contents
