Connection And Operation - Kensence SMC100 Operation Manual

SMC100/200/400/800

3. Connection and Operation

1. Connect signal source such as blu-ray player,game controller,A/V receiver,cables,satellite
receiver etc. to the HDMI input port of the matrix.
2.Connect the output port of the matrix to HD display or HD projector with HDMI input
port.Notice:It's better to use High-Speed HDMI Cable when the transmission distance is too long.
3.Firstly power on the signal source ， then the matrix(with power supply) ， finally devices
connected to the output port .
4.Plug in power to each device in the same order .
5.If all devices are connected properly,every display device should display the specified signal to
make sure the devices are normal.If one of the displays failed to receive signal correctly,enter the
menu of display,adjust the resolution from MIN to MAX until the signal is displayed normally.A
24 Hz vertical refresh rate may work better than 60 Hz or higher.
The following diagram is S-Mix-Pro matrix switching system application:
2