Kensence SMC100 Operation Manual page 16

2) Serial connection:Use a straight serial cable to connect the computer and matrix,
double-click to open the control software, click the "SETUP" button, select the serial port
connected to the matrix, for example, "COM2", then select the serial device "COM2", click
"serial connection", when all the buttons in the lower right corner show green, the connection
is successful. Click "Load" at this time to display some configuration of the matrix, as shown
in Figure 6.3.2
3) Change the matrix IP: Make sure the matrix is connected to the computer. Enter the IP to be
Figure 6.3.1 Network Connection
Figure 6.3.2 Serial Port Connection
13
SMC100/200/400/800