Switch Operation; Input And Output Card Central Control, Resolution, Name Change And Other Operations - Kensence SMC100 Operation Manual

changed in the network address in the configuration bar. Click Save to change the IP
4) Turn on/off the buzzer: Make sure the matrix is connected to the computer. Click the "ON"
button next to the buzzer to turn off or on the buzzer.
Turn on/off video backup: Make sure the matrix is connected to the computer. Click the
5)
"Open" button next to the video backup to close or open the video backup.

6.3-1 Switch operation

Click the switch button to switch between video, USB, and audio (for example, switch video,
click input port 2 on the video interface, and then click Select All, then click Apply, and finally
click Execute); if you want to switch USB, then in the function button zone switches to the USB
option, video, USB, audio, and the three states can be switched back and forth.
6.3-2 Input and output card central control, resolution,
name change and other operations
1） Input card :After double-clicking any input signal on the "SWITCH" interface and popping up
the interface as shown in Figure 6.3.4, you can set this input signal . In the "control" column, we
can control the equipment such as the camera which connected to the card (this function needs to
ask the equipment supplier for relevant information. The command sending format is shown
in Table 1). In the "Video Control" column, you can adjust the brightness ,contrast, and reset the
card of the input card, . In the "Name" column, you can rename the name of the signal.
Figure 6.3.3 Switch interface
14
SMC100/200/400/800