Kensence SMC100 Operation Manual page 15

SMC100/200/400/800
Figure 6.3.0 Computer IP change
Network connection:Network connection: Use a network cable to connect the computer and
1)
matrix, double-click to open the control software, click the "SETUP" button, if you control
the matrix through the network port, you must set the computer IP and matrix IP in the same
network segment, in the network port online Select the computer's IP address in the column
(click the "SETUP" button on the matrix touch screen to view the matrix network address),
and then click the "net port connection" button to connect. When all the buttons in the lower
right corner of the interface are displayed in green, the connection is successful. . At this
point, click on the "Load" button on the interface to display the matrix configuration, as
shown in Figure 6.3.1.
12