Kensence SMC100 Operation Manual page 3

To protect the device and operating personnel from electrostatic discharge, you need to check and
ensure that the device is grounding good before the device is powered on. Please
following when you install, use, maintain this equipment.
 Please use single-phase three wire system AC 220V power supply, and ensure all transmission
system is grounding good.
 To protect operating personnel and the device ,please turn off all power supplies and pull the
plug before moving the device or doing some specific works witch need to be done when the
electricity is turned off . Please turn off the main power switch on rainy days or when not in
use for a long time.
 Please do not put anything upon the cables, or tread the cables .
 To avoid damaging the device , please turn off power supply before plugging cable into the
device or pulling cable from device. The damage caused by plugging/ pulling cables without
turning off power supply is outside the scope of the warranty.
 The power of the device gives out heat when it works, so it's necessary to keep the work
environment ventilated to protect the device from the damage caused by overtemperature.
 Do not place the device in very cold or very hot places. Do not sprinkle any corrosive chemicals
or liquid on or around the device.
 To avoid accident or any further damage ,non-professionals please do not dismantle or maintain
the device without permission.
 Do not sprinkle any corrosive chemicals or liquid on or around the device.
Safety Reminder
Make sure the device ground connection.
SMC100/200/400/800
observe the