Kensence SMC100 Operation Manual page 18

SMC100/200/400/800
Figure 6.3.4 Input central control, resolution, name change and other operations
2）Output card:After you double-click any output signal on the "SWITCH" interface and pop up
the interface as shown in Figure 6.3.5, you can set this output signal of the channel. In the
"control" column, we can control the devices ,such as the camera which the card is connected to
(this function requires the supplier of the equipment to request relevant information. The
format of the command transmission is shown in Table 1). In the "Video Control" column, we
can choose the output resolution supported by the card and adjust the brightness, contrast,
saturation, etc. settings of the signal screen. You can rename the name of the signal in the "Name"
column. .
Figure 6.3.5 output card central control, resolution, name change and
15