Matrix Control Operation Introduction; Panel Control - Kensence FMX Series Operation Manual

Connect the HDCI connector, do not insert joint oppsite so as not to burn the HDCI card.

8.Matrix control operation introduction

8.1Panel control

Switching operation
First select the input port, then select the output port and then press the "ENTER",
select the input and output port using combination forms.
Example 1:Input "1" switch to output "5", press input area "0" and "1" and output port
area"0" and "5", then press "ENTER" key is ok.
Example 2: the input "11" switch to the output "13", press"1" in the "input port area" two
times, and then press "1" and "3" in the output port area and then press "ENTER".
If you want to switch one way to all the output ports, you can use the "ALL" button.
Example 3: input port "3" switch to all output ports, press input port "0" and "3", and then
press the "ALL" button, finally press the "ENTER" button.
During the operation, before the "ENTER" key is pressed, the "CLEAR" key is used to
clear the selected input and output ports.
EDID function key using
Using EDID function key can easily call the output display EDID information, the specific
operation is as follows:
Example 1: input port "2" call the output "8" EDID information, press the "EDID" button,
and then press the input "0" and "2", the output "0" and "8", and finally press "ENTER".