Manual Setting; Laser Setting - RD RDC6445GZ User Manual

Shenzhen Reader Technology Co., Ltd
This item can lock the keys. After entering the correct password, the keys
automatically lock and return to the main interface. When any key is pressed, the
interface prompts the input password to unlock the keys.
Please refer to section 8.9 for password input and password settings.Press the
<Esc> key to return to the previous menu.

8.7.3 Manual setting

Select the "Manual setting" entry under the funtions interface, press the <Enter>
button, and then pop up the interface as follows:
Manual mode has "Continue" and "Manual", press the <Enter> key to enter the
modification mode ("blue selection block" right side becomes
"up/down" key to modify, after the modification, press the <Enter> key to exit the
modification mode. After all modifications, move the "Select block" to the Write
Parameters entry and press the <Enter> key. The parameter settings take effect.
Press <Esc> key to return to the previous menu.
When "Continue" item is selected, then the "Manual" item is not valid, on that time,
push the direction keys to move the corresponding axes, and when the pushed key is
loosed, then the corresponding axes will finish moving. When the Mode item is
"manual", then pushing the direction key one time, the corresponding axes will move
a fixed length, unless the scope is overstepped.

8.7.4 Laser Setting

Select the "Laser setting" entry under the funtions interface, press the <Enter> button,
and then pop up the interface as follows:
Manual mode: Manual
Distance: 1234.5
Press <Enter> or Num key
Figure 8.7.3
39
mm
Read
Write
), press the