Set The Layer Parameters - RD RDC6445GZ User Manual

Shenzhen Reader Technology Co., Ltd
At this point, the "blue selection block" stays on the first parameter to indicate that the
parameter is selected, press the number key and the backspace key to set and
modify the parameter. Press the arrow button to move the "select block" to select
other parameters for modification. When the parameters are modified, press the
<Enter> key to save the parameters, press the <Esc> key to cancel the parameters,
the interface disappears and returns to the main interface.

8.4 Set the layer parameters

After selecting a file to preview on the main interface, If there is layer information in
the layer parameter area, show as below:
User can push <Enter> key to let the cursor move to the first layer show as below:
And then "Up and down" Keys can be pushed to select the intent layer, on that time,
user can push <Enter> key to check the selected layer's parameters, show as below:
Max power1: 99.5
Min power1: 99.5
Max power2: 99.5
Min power2: 99.5
Press <Enter> key when modification
is completed.
Figure 8.3
01 100mm/s 85.5%
02 100mm/s 85.5%
03 100mm/s 85.5%
04 100mm/s 85.5%
Figure 8.4-1
01 100mm/s 85.5%
02 100mm/s 85.5%
03 100mm/s 85.5%
04 100mm/s 85.5%
Figure 8.4-2
26
%
%
%
%