RD RDC6445GZ User Manual page 57

Shenzhen Reader Technology Co., Ltd
（4）Reset parameters

Reset Speed: it means the speed of X/Y-axle linkage reset to the origin.

X axle start-up reset(Auto home)

Y axle start-up reset(Auto home)

Z axle start-up reset(Auto home)

U axle start-up reset(Auto home)
You can select "Yes" or "No" in the field of the above four parameters, which is used
to confirm whether each axle can be reset on the startup.
（4）Go scale parameters
 Go scale Mode: "Blanked Bordering" means idling to start border preview;
"Outputted Border Cutting" can manually cut off the well-processed figure;
"4-corner Dotting" means to emit the light at four corner points of the frame to
make a point and turn off light. The size and position of this figure can be
checked intuitively through the four points. The bordering speed is the speed
value set on the keyboard when the system is idle. For light output, its
minimum/maximum power is the corresponding value set on the keyboard when
the system is idle (The lasering power on the 4-corner dotting means the
well-set maximum power).

Go scale Blank: It means whether to extend a certain length outside the actual
frame of the figure on the preview/cutting of frame.
If the frame crosses the border, the interface will prompt it. If the Enter
key is pressed at this time, the system will cut the border at the
Prompt
maximum/minimum coordinates first, and then border the figure. This
bordering can be given up.
（5）Other user parameters

Array Mode: Two-way array or one-way array can be selected. Two-way array
means the to-and-fro cutting of array in sequence; one-way array means the
cutting of array from one direction to another. On selecting one-way array, the
elements of each array are the same in action mode and completely uniform in
action fluency, which takes a little more time than two-way array. Two-way array
is the default option.

Back Position: The origin (the relative origin) and the machine's absolute origin
can be selected. This parameter decides the parking position of laser head after
each work.

Focus Setting: it means the distance from the focal point of laser head lens to
Z-axle origin. When there is no automatic focusing function, this parameter
becomes invalid.

Backlash X: The X axes' backlash, accurate to 1um.

Backlash Y: The Y axes' backlash, accurate to 1um.
53