RD RDC6445GZ User Manual page 33

Shenzhen Reader Technology Co., Ltd
At this point, the user can press the "up/down" key to select a parameter, press the
number key to modify the numerical parameters (such as "Idle speed"), for
non-numerical parameters (such as "Scan mode"), when the "blue selection block"
stops on the parameter, press the <Enter> key to enter the modification mode (the
"blue selection block" right side becomes
parameters. After the modification, press the <Enter> key to exit the modification
mode. When the current page parameters have been modified, move the "blue
selection block" to the "Write" entry and press the <Enter> key. The panel saves all
the parameters on the motherboard and takes effect, and displays the save progress
on the "Write" entry. If the user wants to verify that the parameters are saved
successfully, he can move the "blue selection block" to the "Read" entry and press
the <Enter> key, then the panel reads the motherboard parameters again and
displays them. When pressing the "left/right" key, the Blue Select Block switches back
to the parameter category, as shown in Figure 8.5.1-1, where the user can select
another parameter category to modify or press <Esc> to return to the menu interface.
Other interface operations are similar, and the interface is displayed as follows:
Cutting para
X start speed:
Sweep para
Y start speed:
Feeding para
Go scale para
Home para
Return para
Line shift speed:
Focusing para
Scan mode:
Working speed
Facula size:
Rotating
Engraving factor:
Other
Figure 8.5.1-3
Cutting para
Sweep para
Feeding para
Go scale para
Go scale mode:
Home para
Go scale blank:
Return para
Focusing para
Working speed
Rotating
Other
Figure 8.5.1-5
12345.678 mm/s
12345.678 mm/s
X Acc: 12345.678 mm/s2
Y Acc: 12345.678 mm/s2
12345.678 mm/s
Normal
00.0 %
100 (0-100)%
Read Write
Close laser
12345.678 mm
Read Write
), press the "up/down" key. Modify the
Cutting para
Sweep para
Delay before feed:
Feeding para
Go scale para
Prograssive feeding:
Home para
Prograssive feeding comp:
Return para
Focusing para
Working speed
Rotating
Other
Cutting para
Sweep para
Feeding para
Go scale para
Home para
Return para
Focusing para
Working speed
Rotating
Other
29
12345.678
Delay after feed: 12345
No
12345.678
Last feeding:
Yes
Read
Figure 8.5.1-4
XY home speed: 12345.678
Z home speed: 12345.678
U home speed: 12345.678
Auto home X:
Yes
Auto home Y:
Yes
Auto home Z:
Yes
Auto home U:
Yes
Read
Figure 8.5.1-6
s
ms
mm
Write
mm/s
mm/s
mm/s
Write