User Parameters - RD RDC6445GZ User Manual

Shenzhen Reader Technology Co., Ltd

8.5.1 User parameters

In the menu interface, select "User parameters" entry and press the <Enter> key ,it
will show as below:
Cutting para
Sweep para
Feeding para
Go scale para
Home para
Return para
Focusing para
Working speed
Rotating
Other
At this point, the panel automatically reads the motherboard parameters and displays
them, while displaying the progress of the read parameters in the "Read Parameters"
entry. When all the parameters are read out, the user can press the "up/down" key to
move the "blue selection block" to select a parameter category such as "carving",
"feeding" and so on. The right parameter area displays the corresponding parameters.
If the user does not need to modify the parameters, press the <Esc> key to return to
the menu interface.
If the user needs to modify the parameters, press the <Enter> button, and the "blue
selection block" switches to the first parameter in the parameter area, as shown in the
following interface:
Cutting para
Sweep para
Feeding para
Go scale para
Home para
Return para
Focusing para
Working speed
Rotating
Other
Idle speed: 12345.678
Idle acc: 12345.678
Idle delay: 12345.678
Start speed: 12345.678
Min acc: 12345.678
Max acc: 12345.678
Acc factor:
Go acc factor:
Speed factor:
Read
Figure 8.5.1-1
:
Idle speed:
12345.678 12345.678
: 12345.678
Idle acc: 12345.678
Idle delay: : 12345.678 12345.678
Start speed: : 12345.678 12345.678
: 12345.678
Min acc: 12345.678
: 12345.678
Max acc: 12345.678
: 123
Acc factor: 123
Go acc factor: : 123 123
Speed factor: : 123 123
Read
Figure 8.5.1-2
28
mm/s
mm/s2
ms
mm/s
mm/s2
mm/s2
123 %(0-200)
123 %(0-200)
123 %(0-200)
Write
mm/s
mm/s
mm/s2
mm/s2
ms ms
mm/s mm/s
mm/s2
mm/s2
mm/s2
mm/s2
%(0-200)
%(0-200)
%(0-200) %(0-200)
%(0-200) %(0-200)
Write