User Parameters - RD RDC6445GZ User Manual

Shenzhen Reader Technology Co., Ltd
After the configuration parameters in the manufacturer parameters, such
as directional polarity, control mode, laser type and laser PWM
Prompt
frequency, are modified, the system should be reset. Such a modification
can function upon the resetting of the system.
Enable parameters

Door Opening Protection: If this item is enabled, then the door opening
protection must be connected to the controller, or, the machine will not run.

Whether to enable the blower: If using wind out port to control the blower by
the graph layer parameter, this item must be enabled, or, the wind output is a
signal for other using.

9.2 User parameters

（1）Cutting parameters(Only affect cutting arts)

Idle Move Speed: this parameter decides the highest speed of all non-lighting
lines for the machine in the movement process.

Idle Move Acceleration: it means the highest acceleration of all non-lighting
lines. Idle stroke speed and idle stroke acceleration can be set higher to reduce
the working time of the whole figure, but if they are set too high, it may cause the
jarring of track, so comprehensive consideration should be given to the setting.

Idle Move Delay：If this parameter is zero, then after idle moving there is no
delay, or, there is delay and the speed will decrease to turn off speed.

Turning Speed: it means the speed of turning at the acute-angle corner, which
is also the highest speed in the whole cutting process.

Turning Acceleration: it means the acceleration of turning at the acute-angle
corner when cutting. If the two speeds are set too high, jarring will happen to the
turning; if set too low, it will influence the cutting speed. This acceleration is the
least value of the whole graph.

Cutting Acceleration: it means the highest acceleration value in the whole
cutting process.

Acc Factor: This parameter indicates how speedy the cutting acceleration is
changing.

G0 Acc Factor: This parameter indicates how speedy the idle move
acceleration is changing.

Speed Factor: This parameter indicates the cutting speed of the arc of various
curvatures.
● Key Setting: This is a button but not a parameter, this button is used to
recommend some experiential cutting parameters.
（2）Scanning parameters(Only affect scanning arts)
51