Exerpeutic 4200 Owner's Manual page 18

OPERATION PROCEDURE:
1. Installs 2 pcs of 1.5V "AAA" batteries, then the screen will display as following
"Drawing A" and have "Beep" sound at the same time.
After that, it goes to the next step to the main menu as "Drawing B".
2. Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE. When
you are in each set- up mode, for example in the time set-up mode, time value is
blinking, you can press "SET" button to adjust the value and press "MODE" for
confirmation. The set-up of DISTANCE, CALORIES & PULSE is the same as
TIME.
3. With any signal been transmitted into the monitor, the value of TIME, DISTANCE,
CALORIES start to count up as Drawing C. When there is any function has been
preset the target (TIME or DISTANCE or CALORIES), the function will be counting
down from the preset to zero while the training starts. Once the target is achieved to
zero, the monitor start to beep for 8 seconds, and the function will be counting up
from zero directly if the training is going. Press "MODE" button for confirmation and
skip to next set-up.
4. In SCAN mode shown as "Drawing C". RPM/SPEED/TM/DIST/CAL/PULSE will
skip to display in every 6 seconds. The order is as follows.
COMPUTER
17