Exerpeutic 4200 Owner's Manual page 12

ASSEMBLY
Tool:
Allen Wrench S6
Multi Hex Tool with Phillips Screwdriver
S13, S14, S15
1.Handlebar Post Installation
Turn the Round Knob (8) on the Main Frame (39) in a counterclockwise direction until it
can be pulled out. Pull out the Round Knob (8) and then insert the Handlebar Post
(22) into the tube of the Main Frame (39). Slide the Handlebar Post (22) up or down
direction to the suitable position. Lock the Handlebar Post (22) in place by releasing
the Round Knob (29) and sliding the Handlebar Post (22) up or down slightly until the
Round Knob (8) "pops" down into the locked position. For added safety, tighten the
Round Knob (8) in a clockwise direction.
NOTE: When adjusting the height of seat post, the MAX line cannot be higher than
the edge of plastic bushing.
2. Handlebar Installation
Attach the Handlebar (23) onto the Handlebar Post (22) . Through Two Hexagon
Socket Pan Head Cap Bolts (24), Two and Washers (25) . Tighten bolts (24) with the
S6 Allen Wrench and Multi Hex Tool with Phillips Screwdriver. .
3.Computer Installation.
Use 6mm Allen Wrench to install the Computer (37) into the computer plate on the
handle bar and tighten with Phillips pan head cap screw (38).
4. Insert the Sensor Trunk (36) through into the bottom end of Handlebar Post (22) and
pull it out from the top end of Handlebar Post (22) connect the Sensor Wire (35).
Connect computer wire (37a) with the sensor wire (35) and handlebar wire (34) into the
Computer(37)
11