Exerpeutic 4200 Owner's Manual page 11

ASSEMBLY
Tool:
Multi Hex Tool with Phillips Screwdriver
1. Seat Post, Seat, Seat Sliding Tube, and Handlebar Post Installation
Seat Post Installation
Turn the Round Knob (8) on the Main Frame (39) in a counterclockwise direction until it
can be pulled out. Pull out the Round Knob (8) and then insert the Seat Post (3) into
the tube of the Main Frame (39). Slide the Seat Post (3) up or down direction to the
suitable position. Lock the Seat Post (3) in place by releasing the Round Knob (8)
and sliding the Seat Post (3) up or down slightly until the Round Knob (8)"pops" down
into the locked position. For added safety, tighten the Round Knob (8) in a clockwise
direction.
NOTE: When adjusting the height of seat post, the MAX line cannot be higher than
the edge of plastic bushing.
2. Seat Installation
Turn the Round Knob (4) on the Seat Post (3) in a counterclockwise direction until it can
be pulled out. Pull out the Round Knob(4) and then put the Seat Bracket (2) onto the
Seat Post (3). Slide the Seat Bracket (2) in place by releasing the Round Knob(4) and
sliding the Seat Bracket (2) back and for the slightly until the Round Knob (4) "pop" down
in the locked position. For added safety, tighten the Round Knob (4) in a clockwise
direction. Put the Seat(1) onto the Seat Bracket (2). Then tighten the Seat (1) with Multi
Hex Tool with Phillips Screwdriver onto the Seat Bracket (2).
10