ResMed Mirage Vista User Manual page 9

3 Thread strap BR through the buckle on
Part A. Thread strap BL through the
buckle on Part D (Fig. F-3).
4 Thread the straps of Part A and Part D
through the buckles on Part B (Fig. F-4).
5 With the headgear clip facing down, fit
the headgear clip onto the hole on the
headgear. While pressing the headgear
tab down, rotate the headgear clip away
from the tab to lock it into place
(Fig. F-5). Repeat this with the other
headgear clip.
T S
ECHNICAL PECIFICATIONS
P –F C
RESSURE LOW
See Figure A.
Note:
The mask contains passive venting to
protect against rebreathing. As a result of
manufacturing variations, the vent flow rate
may vary.
D S I
EAD PACE NFORMATION
Dead space is the empty volume of the
mask up to the swivel.
The dead space of the mask for all cushion
sizes is 80 mL.
S
YMBOLS
Caution, consult accompanying
documents; Batch Code;
LOT
Catalogue Number;
Authorised Representative;
Temperature limitation;
Humidity limitation;
contain natural rubber latex;
Manufacturer;
or Caution and alerts you to a possible
Note:
Translations are based on the English version in this guide. However, there may be minor
variations based on the disinfection/sterilisation procedures applicable in some countries. ResMed
has reviewed these changes and all procedures included here have been validated.
URVE
European
Does not
Indicates a Warning
injury or explains special measures for the
safe and effective use of the device.
R P
EPLACEMENT
Part No. Item
60918 Headgear Assembly, Standard
61020 Headgear Assembly, Small
60013 Cushion, Small
60921 Cushion, Standard
60922 Cushion, Deep
60919 Headgear clip - blue (2 pk.)
60920 Headgear clip - blue (10 pk.)
60023 Crossover buckle - blue
60024 Crossover buckle - blue
(10 pk.)
60924 Mask Frame
60925 Elbow Assembly
60926 Inlet Tube and Swivel Assembly
60927 Inlet Tube and Swivel Assembly
(10 pk.)
60014 Swivel Assembly (10 pk.)
16570 Ports cap (2 pk.)
16571 Ports cap (10 pk.)
60004 Mask System, Deep Cushion
- Standard Headgear
60003 Mask System, Standard Cushion
- Standard Headgear
L W
IMITED ARRANTY
ResMed warrants that your ResMed mask
system, including its components: mask
frame, cushion, headgear, tubing and other
accessories ("Product") shall be free from
defects in material and workmanship for a
period of ninety (90) days from the date of
purchase by the initial consumer.
For further details refer to the Warranty.
ARTS