Removing The Mask; Disassembling For Cleaning; Cleaning The Mask In The Home - ResMed Mirage Vista User Manual

10 If you feel air leaks around the cushion,
reposition the mask on your face to
achieve a better seal.
Take time to adjust all straps and the
position of the mask so that you can
achieve a secure and comfortable fit.
Notes:
If you are unable to resolve any leaks you
•
may need to try another cushion size.
Excess headgear length may be trimmed
•
to a suitable length if required. Leave at
least 30 mm free length on the straps.
Select "Standard" as the mask option
•
when using the Mirage Vista with ResMed
flow generators that have mask setting
options. For a full list of compatible devices
for this mask, see the Mask/Device
Compatibility List on www.resmed.com on
the Products page under Service &
Support. If you do not have internet access,
please contact your ResMed
representative.
R
EMOVING THE
To remove the Mirage Vista, squeeze one
of the headgear clips. This releases one side
of the headgear from the mask. Pull the
mask and headgear away from your head.
Notes:
Do not pull the headgear off your head
•
without releasing the headgear clips first.
You can detach the elbow from the mask
•
frame while wearing the mask. This is
useful when therapy needs to be stopped
for a short time; for example if you need to
go to the bathroom.
Check that you can remove the headgear
•
clip, the quick release swivel or the
headgear unaided.
M
ASK
D
ISASSEMBLING FOR
See Figure D.
1 Detach the mask elbow. To do this,
squeeze the sides of the mask elbow at
the finger grips while pulling it away from
the mask frame (Fig. D-1).
2 Disconnect and separate the main air
tubing, short air tubing, mask elbow and
vent cover (Fig. D-2).
Notes:
To prevent damage to the short air
•
tubing, disconnect it by holding it at the
cuff.
The swivel does not need to be
•
disconnected from the short air tubing.
3 Detach the headgear from the mask
frame by squeezing and releasing both
headgear clips.
4 Remove the ports cap from the mask
frame (Fig. D-3).
5 Firmly pull the mask cushion away from
the mask frame (Fig. D-4).
C
LEANING THE
H
OME
Notes:
Wash the headgear before first time use,
•
as the dye may run. It is important to
always handwash the headgear.
The headgear may be washed without
•
being disassembled.
W
EEKLY
Handwash the headgear in warm, soapy
water. Use pure soap (see first caution
below). Rinse well and allow it to air dry out
of direct sunlight.
D /A
AILY FTER EACH USE
Handwash the mask components in
lukewarm, soapy water. Use pure soap (see
first caution below). Rinse the components
C
LEANING
M
ASK IN THE