sauter FP Series Instruction Manual page 10

7. Data: peak and tracking value storage place
If typeface is white, this means that it has a storage data
If typeface is not white, this means that it has no storage data
8. Zero: press to clean the peak and tracking value
9. Store: press the button to save the current peak and tracking value to a relevant
Data place. If the data place has got a storage value, then replace the value
10. : the first function button; by pressing it, it will switch from
ZERO/STORE/START
11. Curve: press to get to the curve view interface
12. Data: press to get to data view interface
13. Unit: press to change units among N/kgf/ lbf/ ozf.
14. Back: the second function button; by pressing this, it will switch from
CURVE/DATA/UNIT..../BACK button to ZERO/STORE/START/....
15. Start: press to enter to testing interface for curve draw dot
5) Measurement curve draw dot interface
1. Current measurement value
2. Current measurement time, unit is "seconds"
3. Grade value: if the test value exceeds grade value, it will switch to next grade
4. Upper limit line (red): if the upper limit value exceeds grade value, the upper limit
line will not be shown
5. Lower limit line (yellow): if the lower limit value exceeds grade value, the lower limit
Line will not be shown.
6. Testing curve: the changed curve of the force value during the testing process
7. Upper and lower limit, sectional area and intensity indication:
If the pressure parameter of the tested material is "Yes", sectional area and pres-
sure will be indicated; see picture 10
If the pressure parameter of the tested material is "No", upper and lower limit value
will be indicated; see picture 9.
8. Stop: testing stop and go to storage interface see picture 11
10
to CURVE/DATA/UNIT/BACK button
FP-BA-e-1610