sauter FP Series Instruction Manual page 9

1. Upper limit: if the measured value is above the upper limit, the buzzer alarms con-
tinuously.
2. Lower limit: if the measured value is below the upper limit, the buzzer alarms once.
3. Machine stop: When the instrument is connected to a test stand, the test stand will
stop when the value on the instrument is bigger than the stop value of the test stand.
4. Acceleration: the gravity acceleration has to be set according to the conditions,
range: 9.70, 00≈9.8999.
5. Peak-hold time: 1-99 s, „0" means not releasing peak.
6. Drawpoint: interval of curve drawpoint (0.1≈ 0.5 seconds setting)
7. Power off time: setting from 1 to 99 minutes. "0" means not power off automatically
8. Whether to turnover display
9. Whether to make a pressure test or not
10. Material sectional area
Note: Move
pressing . When the modification is finished, press
tial.interface.
4) Initial Interface
1. Peak
2. Tracking value
3. Grade value: while the curve is drawpointing and the test value exceeds the grade
value, it will switch to next grade
4 Region of curve display
5. Curve drawpointing x- coordinate unit: seconds
6. Upper or lower limit, sectional area or pressure indication
If the parameter of testing material pressure is "yes", then the sectional area and
Pressure is displayed; see picture 7.
If the parameter of testing material intensity is "no", then the upper and lower limit
Is displayed; see picture 8.
FP-BA-e-1610
to the matching option, then modify the parameter by
and return to the ini-
9