Danfoss VLT HVAC Drive FC 100 Series Design Manual page 94

5. How to Install
5.2.17. Motor connection for B3 and B4
5
Illustration 5.27: First terminate the motor earth, then Place motor U,
V and W wires in terminal and tighten. Please ensure that the outer
insulation of the motor cable is removed under the EMC clamp.
5.2.18. Motor connection for C1 and C2
Illustration 5.29: First terminate the motor earth, then Place motor U, V and W wires in terminal and tighten. Please ensure that the outer insulation
of the motor cable is removed under the EMC clamp.
94
Illustration 5.28: First terminate the motor earth, then Place motor U,
V and W wires in terminal and tighten. Please ensure that the outer
insulation of the motor cable is removed under the EMC clamp.
MG.11.B7.02 - VLT ® is a registered Danfoss trademark
®
VLT HVAC Drive Design Guide