Danfoss VLT HVAC Drive FC 100 Series Design Manual page 81

®
VLT HVAC Drive Design Guide
5.2.6. Gland/Conduit Entry - IP21 (NEMA 1) and IP54 (NEMA12)
Cables are connected through the gland plate from the bottom. Remove the plate and plan where to place the entry for the glands or conduits. Prepare
holes in the marked area on the drawing.
The gland plate must be fitted to the frequency converter to ensure the specified protection degree, as well as ensuring proper cooling of the unit. If the
gland plate is not mounted, it may trip the unit.
Enclosure D1 + D2
Enclosure E1
Cable entries viewed from the bottom of the frequency converter - 1) Mains side 2) Motor side
MG.11.B7.02 - VLT ® is a registered Danfoss trademark
5. How to Install
5
81