Danfoss VLT HVAC Drive FC 100 Series Design Manual page 93

®
VLT HVAC Drive Design Guide
5.2.15. Motor connection for A5
Illustration 5.25: First terminate the motor earth, then place motor U, V and W wires in terminal and tighten. Please ensure that the outer insulation
of the motor cable is removed under the EMC clamp.
5.2.16. Motor connection for B1 and B2
Illustration 5.26: First terminate the motor earth, then Place motor U, V and W wires in terminal and tighten. Please ensure that the outer insulation
of the motor cable is removed under the EMC clamp.
MG.11.B7.02 - VLT ® is a registered Danfoss trademark
5. How to Install
5
93