Danfoss VLT HVAC Drive FC 100 Series Design Manual page 100

5. How to Install
5
Illustration 5.33: Control terminals (all enclosures)
5.2.23. Electrical Installation, Control Cable Terminals
To mount the cable to the terminal:
1. Strip isolation of 9-10 mm
2.
Insert a screw driver
3. Insert the cable in the adjacent circular hole.
4. Remove the screw driver. The cable is now mounted to the ter-
minal.
To remove the cable from the terminal:
1.
Insert a screw driver
2. Pull out the cable.
1) Max. 0.4 x 2.5 mm
100
1) in the square hole.
1) in the square hole.
MG.11.B7.02 - VLT
1.
2.
® is a registered Danfoss trademark
®
VLT HVAC Drive Design Guide
3.