Danfoss VLT HVAC Drive FC 100 Series Design Manual page 85

®
VLT HVAC Drive Design Guide
5.2.8. Mains connection for A2 and A3
Illustration 5.9: First mount the two screws on the mounting plate, slide it into place and tighten fully.
Illustration 5.10: When mounting cables, first mount and tighten earth cable.
The earth connection cable cross section must be at least 10 mm
IEC 61800-5-1
.
2 or 2 rated mains wires terminated separately according to
MG.11.B7.02 - VLT ® is a registered Danfoss trademark
5. How to Install
5
EN 50178/
85