Sending The Results To The Telemedical Center; Troubleshooting The Mobile App - Braster In-home Breast Examination System User Manual

2) One upper application to the outer part of your breast, on the border with your axilla, making sure that the edge of the matrix,
i.e. the black part (the thermographic foil), touches upon the lateral edge of your breast and does not extend beyond it.
3) One upper application to the inner part of your breast, making sure that the edge of the matrix, i.e. the black part (the
thermographic foil), does not extend to your other breast and your sternum.
The applications may overlap, but do not worry if in your case they do not overlap as shown in the illustrations. The crucial thing
is to make sure that your entire breast is covered.
Follow the instructions displayed on the screen of your mobile device. Each application takes about 15 seconds which may
be extended for transfer if the WiFi conditions are poor (a lot of other transmitters or radio noise). The time interval between
applications lasts approximately 10-15 seconds (depending on your breast temperature and the ambient temperature). The
matrix should not be in contact with your body during this time.
Breast size 4 or 5
If your breast size is 4 or 5 see Fig. 10A for size 4 and Fig. 10B for size 5, during the examination you will have to perform:
1) One central application to your breast, making sure that the lower edge of the matrix, i.e. the black part (the thermographic
foil), adheres to your breast (not your abdomen). Do not push your breast up.
Divide the breast into four equal quadrants, as if there was a vertical and a horizontal line crossing the center of your breast.
Now perform:
2) One application to the lower-outer quadrant of your breast, making sure that the lower edge of the matrix, i.e. the black part
(the thermographic foil), adheres to your breast (not your abdomen). Do not push your breast up.
3) One application to the upper-outer quadrant of your breast, on the border with the axilla, making sure that the edge of the
matrix, i.e. the black part (the thermographic foil), touches upon the lateral edge of the breast and does not extend beyond it.
4) One application to the upper-inner quadrant of your breast, making sure that the edge of the matrix, i.e. the black part (the
thermographic foil), does not extend to your other breast but runs across the centerline of your sternum.
5) One application to the lower-inner quadrant of your breast. The lower edge of the matrix, i.e. the black part (the thermographic
foil), should adhere to your breast (not your abdomen). Do not push the breast up.
22
The applications may overlap, but do not worry if in your case they do not overlap as shown in the illustrations. The crucial thing
is to make sure that your entire breast is covered.
Follow the instructions displayed on the screen of your mobile device. Each application takes about 15 seconds which may
be extended for transfer if the WiFi conditions are poor (a lot of other transmitters or radio noise). The time interval between
applications lasts approximately 10-15 seconds (depending on your breast temperature and the ambient temperature). The
matrix should not be in contact with your body during this time.

7.2.8. SENDING THE RESULTS TO THE TELEMEDICAL CENTER

Once you have made all applications, you will be informed that the examination has come to an end and that you are able to
send your collected data to the manufacturer's telemedical center for analysis. Please note that before you send the data,
you should first disconnect your mobile device from the Braster device and connect to a WiFi network. Due to the size of the
thermographic images produced during the examination, it is not recommended to send them via mobile data but by a WiFi
network. The examination results will be sent to your account on myaccount.braster.eu within two business days.
If you select "Finish" after having sent the examination, you will be redirected to the start screen, where you can check the
status of the examination ("Sent for analysis"). When the results of the examination have been sent to your account from the
telemedical center, the status will change to "Result available".
You do not need to send the collected data for analysis immediately after completing the examination. You can send them
whenever it is convenient for you, when you have access to Internet (preferably via WiFi). When you are ready, go to the app
and select "List of examinations", click on the last exam and choose whether to send it or delete it. Please note that you must
either delete the results or send them for analysis before you carry out a new examination, otherwise the system will not let
you perform your next exam.
The app will let you know when the result of your examination is available. To read it, go to your individual account on myaccount.
braster.eu.

8. TROUBLESHOOTING THE MOBILE APP

In certain circumstances, carrying out an examination will not be possible. Below you may find tips on how to troubleshoot
certain problems.
8.1. The Braster device uses WiFi technology to transmit data to the mobile device. WiFi technology, by design, relies on
sharing radio bandwidth with other users. If the WiFi environment in your location is overcrowded and/or many other WiFi
23