Clarke CBTSR Operation & Maintenance Instructions Manual page 5

• Tie long hair back in a hair net.
9. Use protective equipment.
• Wear protective goggles.
• Wear a mask when carrying out dust-creating work.
10. Connect the dust extraction device if you will be processing wood,
materials similar to wood, or plastics.
• If connections for dust extraction and a collecting device are present,
make sure that they are connected and used properly.
• When processing wood, materials similar to wood, and plastics.
Operation in enclosed spaces is only permitted with the use of a suitable
extraction system.
11. Do not use the cable for purposes for which it is not intended.
• Do not use the cable to pull the plug out of the outlet. Protect the cable
from heat, oil and sharp edges.
12. Secure the workpiece.
• Use the clamping devices or a vice to hold the workpiece in place. In
this manner, it is held more securely than with your hand.
• An additional support is necessary for long workpieces (table, trestle,
etc.) in order to prevent the machine from tipping over.
• Always press the workpiece firmly against the working plate and stop in
order to prevent bouncing and twisting of the workpiece.
13. Avoid abnormal posture.
• Make sure that you have secure footing and always maintain your
balance.
• Avoid awkward hand positions in which a sudden slip could cause one
or both hands to come into contact with the cutter bit.
14. Take care of your tools.
• Keep cutting tools sharp and clean in order to be able to work better
and more safely.
• Follow the instructions for lubrication and for tool replacement.
• Check the connection cable of the electric tool regularly and have it
replaced by a recognised specialist when damaged.
• Check extension cables regularly and replace them when damaged.
• Keep the handle dry, clean and free of oil and grease.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
5