Table of Contents
Advertisement
Vehicle fuses
Below the driver side dash panel:
Fig. 81
fuse box cover
In the engine compartment: fuse box
Fig. 82
cover
Read the additional information carefully
›››
page 37
Only replace fuses with a fuse of the same
amperage (same colour and markings) and
size.
82
Emergencies
Opening and closing the fuse box situated
below the dash panel
●
Opening: Press the unlock button
›››
Fig. 81
until it is possible to open the
1
cover. Fold the cover down.
●
Closing: Fold the cover up in the opposite
direction to the arrow until it clicks into the
locking lever
.
1
To open the engine compartment fuse box
›››
Open the bonnet
page
186.
●
●
Press the attachment tabs in the direction
indicated by the arrow (thin arrows) to re-
›››
lease the fuse box cover
Fig.
●
Then lift the cover out.
●
To fit the cover, place it on the fuse box.
Push the attachment tabs down, in the oppo-
site direction indicated by the arrow until
they click audibly into place.
CAUTION
●
Always carefully remove the fuse box cov-
ers and refit them correctly to avoid problems
with your vehicle.
●
Protect the fuse boxes when open to avoid
the entry of dust or humidity. Dirt and humid-
ity inside fuse boxes can cause damage to
the electrical system.
Note
In the vehicle, there are more fuses than
those indicated in this chapter. These should
only be changed by a specialised workshop.
Changing bulbs
Introduction
Changing bulbs requires a certain amount of
manual skill. If you are unsure, SEAT recom-
mends that you consult a technical service or
82.
request assistance from a specialist. In gen-
eral a specialist is needed if, in addition to
the bulbs, other vehicle components require
removal.
You should store spare light bulbs in the ve-
hicle for safety-relevant lights. Spare bulbs
may be obtained from the technical services.
In some countries, it is a legal requirement to
carry spare bulbs in the vehicle.
Driving with faults and blown bulbs on the
vehicle exterior lighting is against the law.
Additional bulb specifications
The specifications of some headlamp bulbs
and bulbs for the tail lamps fitted at the fac-
tory may be different to those of conventional
bulbs. Bulb information is displayed on the
bulb socket or on the bulb itself.
Advertisement
Table of Contents
