Configuring John Deere Settings
3. Configuring John Deere Settings
Before configuring Zone Control settings, make sure that the John Deere settings listed below
are correctly configured.
1. Navigate to the Setup screen:
a. Tap
b. Tap GS3 (GreenStar).
c. Tap
in the upper right corner.
d. Add a check mark the following boxes: Resources, Machine, Implement,
Documentation, and Section Control. It is okay if other boxes are automatically
checked by default.
e. Tap Accept.
600890-000059, rev 1.1
in the lower right corner.
Figure 2: JD Main settings screen
Engage Zone Control Operator's Guide
Page 6 of 25
Need help?
Do you have a question about the Engage Zone Control and is the answer not in the manual?