Figure 13: Section Ordering With Two Gates Mapped To One Section; Figure 14: Intelligent Ag Time Of Flight Compensation - IntelligentAg Engage Zone Control Operator's Manual

Configuring Engage Zone Control Application
EXAMPLE 3: If your air seeder has two rows of four manifolds (two gates mapped to
one section), manifolds 1-4 in the front correspond with gates 1-4 of the unit. Manifolds
1-4 in the back correspond with gates 5-8 of the unit. Configure your section ordering
like the image below.

Figure 13: Section ordering with two gates mapped to one section

3. Section Width: Input the width of each toolbar section.
4. Time of Flight Compensation: Time of flight compensation supplements the JD turn
on/turn off times by accounting for the time it takes product to travel to each individual
section. Measure this by following the procedure below.
a. For each section of each bin with fan running at operating speed, manually actuate
your meter and use a stopwatch to time how many seconds it takes the seed to get
to the ground.
b. Input these times into the Time of Flight Compensation section of the Intelligent Ag
Section Settings screen.
IMPORTANT: Re-measure these times if you make any large changes in product rate,
fan speed, or product type.
5. Implement Type: Implement is type 1.
6. Tap Save.
600890-000059, rev 1.1

Figure 14: Intelligent Ag time of flight compensation

Engage Zone Control Operator's Guide
Page 14 of 25