IntelligentAg Engage Zone Control Operator's Manual page 25

Troubleshooting
An unmapped motor
controller with serial number
XX has disconnected from
the control unit.
Motor controller with serial
number XX on bin X on the
left side has disconnected
from the control unit.
Haven't found the tractor
speed; the covered area
statistics may be inaccurate.
Bin X gate X has
encountered an obstruction.
Bin X gate X is not moving.
ACTION REQUIRED!
600890-000059, rev 1.1
Ensure that the motor controller with that serial number is
powered on and communicating. Refer to the LED codes below:
Solid red: Powered on and communicating.
•
Flashing red: Powered on but not communicating.
•
Fast flashing red: Firmware update in progress.
•
Ensure that the motor controller with that serial number is
powered on and communicating. Refer to the LED codes below:
Solid red: Powered on and communicating.
•
Flashing red: Powered on but not communicating.
•
Fast flashing red: Firmware update in progress.
•
GPS data isn't available to the Gateway with current GPS
setup. The acre counter won't work.
1. Close and open the gate with the obstruction.
a. Tap Config on the right Intelligent Ag navigation.
b. Tap Diagnostics.
c. Tap Open this gate.
d. Tap Close this gate.
2. Visually inspect the unit for obstructions.
a. Unplug the Engage Zone Control unit bin harness.
b. Remove the bottom meter cover and top lid and clean
product buildup that is impeding gate movement. Refer
to the Engage Zone Control Maintenance Manual
(600840-000047) for cleaning procedures.
c. Re-connect the bin harness.
Visually inspect the unit for obstructions.
1. Unplug the Engage Zone Control unit bin harness.
2. Remove the bottom meter cover and top lid and clean
product buildup that is impeding gate movement. Refer to
the Engage Zone Control Maintenance Manual (600840-
000047) for cleaning procedures.
3. Re-connect the bin harness.
Contact your Intelligent Ag dealer if there are no obstructions.
Engage Zone Control Operator's Guide
Page 25 of 25