IntelligentAg Engage Zone Control Operator's Manual page 23

Troubleshooting
The work switch status is
reversed (green when the
implement is raised, and grey
when the implement is lowered)
600890-000059, rev 1.1
1. Disable Engage Zone Control.
a. Tap Config on the right navigation.
b. Tap Settings.
c. Uncheck the Engage Zone Control Enabled box
at the bottom of the page.
d. Tap Config on the right navigation. The gateway
will reboot.
2. Change the status of the work switch.
a. Tap Config on the right navigation.
b. Tap Configure, then tap Next.
c. Change the status of the box below Is the work
switch reversed?.
• If the box is checked, uncheck it.
• If the box is unchecked, check it.
d. Tap Next, then tap Save.
3. Re-enable Engage Zone Control.
a. Tap Config on the right navigation.
b. Tap Settings.
c. Re-check the Engage Zone Control Enabled box
at the bottom of the page.
d. Tap Config on the right navigation. The gateway
will reboot.
4. Navigate back to the Intelligent Ag Gates screen and
verify that the work switch status is correct.
Engage Zone Control Operator's Guide
Page 23 of 25