Figure 7: Jd Documentation Settings - IntelligentAg Engage Zone Control Operator's Manual

Configuring John Deere Settings
6. Modify Documentation settings.
a. Ensure that a value is selected for items with a red asterisk.
b. Tap
IMPORTANT: To modify Documentation settings after initial configuration, you must
disable Zone Control in the Gates page. Refer to Section 5.3 for instructions to navigate
to the Gates page, then uncheck Zone Control Enabled.
Unchecking this disables the control and mapping of the system. Only uncheck this if
you want to change documentation settings in the 2630. Re-check it if you want to use
mapping and section control again.
600890-000059, rev 1.1
to save the settings.

Figure 7: JD documentation settings

Engage Zone Control Operator's Guide
Page 10 of 25