Viewing Diagnostics; Figure 20: Intelligent Ag Gate Diagnostics Screen - IntelligentAg Engage Zone Control Operator's Manual

Viewing Diagnostics

6. Viewing Diagnostics
Viewing diagnostics is typically only used for troubleshooting and maintenance. Use the main
Engage Zone Control screen to manually control a section.
1. Tap Config on the right Intelligent Ag navigation.
2. Tap Diagnostics.
IMPORTANT: Only navigate to this screen when the toolbar is raised so that section
control commands are not received during gate positioning.
Button
Open This Gate
Close This Gate
Open This Bin
Close This Bin
Open All Bins
Close All Bins
Reposition This Gate
600890-000059, rev 1.1

Figure 20: Intelligent Ag Gate Diagnostics screen

Function
Opens a gate.
Closes a gate.
Opens all gates on a bin.
Closes all gates on a bin.
Opens all gates on all bins.
Closes all gates on all bins.
Recalibrates a gate (used when
troubleshooting an error).
IMPORTANT: Start the fan before
repositioning a gate to make sure
that there isn't debris in the gate
area.
Engage Zone Control Operator's Guide
Figure 20 example
Opens Gate 1 on Bin 1.
Closes Gate 1 on Bin 1.
Opens all gates on Bin 1.
Closes all gates on Bin 1.
Opens all gates on all bins.
Closes all gates on all bins.
Recalibrates Gate 1 on Bin 1.
Page 20 of 25