Modifying Intelligent Ag Section Settings; Figure 10: Engage Zone Control Unit Gate Numbering; Figure 11: Standard Section Ordering; Figure 12: Section Ordering With Sections Off - IntelligentAg Engage Zone Control Operator's Manual

Configuring Engage Zone Control Application

4.2. Modifying Intelligent Ag Section Settings

Enter the information below according to your air cart setup.
1. Number of Bins: Input the number of bins on your air cart.
2. Section Ordering: Configure section ordering in the application based on the section
ordering on your toolbar. Numbers 1-8 in the application corresponds with a gate on the
Engage Zone Control unit, as shown in Figure 10.
IMPORTANT: Not all primary lines are connected to the manifold in sequential order.
Make sure that your primary lines correspond with these gate assignments. If they don't,
re-order the primaries to match these gate assignments.
EXAMPLE 1: If your air seeder has 8 sections, configure your section ordering like the
image below.
EXAMPLE 2: If your air seeder has 6 sections, select Off for the two gate positions you
are not using. A 6-section air seeder doesn't use sections 7 and 8.
In the example below, gates 4 and 5 are off.
600890-000059, rev 1.1

Figure 10: Engage Zone Control unit gate numbering

Figure 11: Standard section ordering

Figure 12: Section ordering with sections off

Engage Zone Control Operator's Guide
Page 13 of 25