Cleaning And Storage; Troubleshooting; Common Issues - IntelligentAg Engage Zone Control Operator's Manual

Cleaning and Storage

7. Cleaning and Storage
At the end of the season, refer to the Engage Zone Control Maintenance Manual (600840-
000047) for storage and cleaning best practices.

8. Troubleshooting

8.1. Common Issues

Problem
The Intelligent Ag application
does not appear on the John
Deere main menu.
I can't edit Section Control
settings during JD auto-configure.
Coverage is mapping on the 2630
but section control isn't operating.
I can't edit JD Documentation
settings when Zone Control is
running.
Gates won't reposition.
600890-000059, rev 1.1
Troubleshooting steps
1. Verify that the Gateway 300 has power (green LED).
2. Verify that the Gateway 300 is wired according to
Section 3 of the Engage Zone Control Installation
Instructions (600840-000043).
Make sure that you have section control enabled.
1. Tap GreenStar.
2. Tap GS3.
3. Tap Activations.
4. Press the down arrow.
5. Ensure that Section Control has a checkmark.
1. Make sure that Zone Control Enabled is checked in
the Engage Zone Control screen.
2. Make sure that Section Control Master is checked
on the JD Section Control settings screen.
3. Verify that the work switch is active in the top left
corner of the Intelligent Ag Gates screen.
Uncheck Zone Control Enabled on the Engage Zone
Control screen.
1. Run the fan to blow out any product that could be
blocking gate movement.
2. Check for product buildup.
a. Unplug the Engage Zone Control unit bin
harness.
b. Remove the bottom meter cover and top lid and
clean product buildup that is impeding gate
movement. Refer to the Engage Zone Control
Maintenance Manual (600840-000047) for
cleaning procedures.
c. Re-connect the bin harness.
Engage Zone Control Operator's Guide
Page 22 of 25